– In the default configuration, the features of the FortiLink port are limited, and in the settings for physical network interfaces (Network Interfaces), this port is not found. In this article, I will show you how to display the above FortiLink ports Firewall FortiGate if more than 1 FortiLink port is enabled using the CLI.
Enable a physical network port or a LACP port such as FortiLink using CLI commands:
config system interface
edit
set vdom “root”
set fortilink enable
next
end
edit
set vdom “root”
set fortilink enable
next
end
The FortiLink ports are now displayed on the device’s GUI management page.
Create a FortiLink gateway in the GUI:
1. On the FortiGate device, log in to the page Dashboard > WiFi & Switch Controller > FortiLink Interface and click Create New.
2. Configure necessary settings (IP, Mask, DHCP, Administrator Access…)
2. Configure necessary settings (IP, Mask, DHCP, Administrator Access…)
3. Click OK. FortiLink ports are displayed like other ports.
Additions in GUI for WiFi and Switch Controller:
The FortiLink port is displayed and can be selected to manage incoming devices in the list on the following GUI pages: here I select FortiLink Port 10
View list of managed FortiSwitches:
List of FortiSwitch groups:
Managing VLANs on FortiSwitch:
FortiSwitch ports:
NAC policies for FortiSwitch:
When you need to create a new Trunk Group, the FortiLink portal will display in the information page on the right:
Connection diagrams:
– On page WiFi & Switch Controller > Managed FortiSwitch, looking at the connection diagram you will see the FortiSwitches in connection with the FortiLink port cluster. In the following example, port newLink There are currently no FortiSwitches connected to it.
– On page Security Fabric > Physical Topologymove the mouse to FortiSwitch to view FortiLink Interface (this port is being used by FortiSwitch).
– Wishing you success-
Xem tiếp...
