This article will guide you to configure Stack on Huawei switch devices. In the example, we will Stacking 4 Huawei S5735-L24T4X-A1 switch devices.
– Connect to Switch 1 to configure the port stack and put the port into the newly created port stack, in this example it is XGE0/0/3 and XGE0/0/4
system-view
(HUAWEI) sysname Switch01
(Switch01) interface stack-port 0/1
(Switch01-stack-port0/1) port interface XGigabitEthernet 0/0/3 enable
(Switch01-stack-port0/1) quit
(Switch01) interface stack-port 0/2
(Switch01-stack-port0/2) port interface XGigabitEthernet 0/0/4 enable
(Switch01-stack-port0/2) quit
– Next configure Priority (default Priority is 100) and slot member for the switch.
(Switch01) stack slot 0 priority 200
(Switch01) stack slot 0 renumber 1
– Finally save the configuration.
(Switch01) save
– Similar configuration as above for Switches 2,3,4, we only change Priority and Slot member.
system-view
(HUAWEI) sysname Switch02
(Switch02) interface stack-port 0/1
(Switch02-stack-port0/1) port interface XGigabitEthernet 0/0/3 enable
(Switch02-stack-port0/1) quit
(Switch02) interface stack-port 0/2
(Switch02-stack-port0/2) port interface XGigabitEthernet 0/0/4 enable
(Switch02-stack-port0/2) quit
(Switch02) stack slot 0 priority 190
(Switch02) stack slot 0 renumber 2
(Switch02) save
system-view
(HUAWEI) sysname Switch03
(Switch03) interface stack-port 0/1
(Switch03-stack-port0/1) port interface XGigabitEthernet 0/0/3 enable
(Switch03-stack-port0/1) quit
(Switch03) interface stack-port 0/2
(Switch03-stack-port0/2) port interface XGigabitEthernet 0/0/4 enable
(Switch03-stack-port0/2) quit
(Switch03) stack slot 0 priority 180
(Switch03) stack slot 0 renumber 3
(Switch03) save
system-view
(HUAWEI) sysname Switch04
(Switch04) interface stack-port 0/1
(Switch04-stack-port0/1) port interface XGigabitEthernet 0/0/3 enable
(Switch04-stack-port0/1) quit
(Switch04) interface stack-port 0/2
(Switch04-stack-port0/2) port interface XGigabitEthernet 0/0/4 enable
(Switch04-stack-port0/2) quit
(Switch04) stack slot 0 priority 170
(Switch04) stack slot 0 renumber 4
(Switch04) save
– Then turn off the power to all Switches, and connect the DAC wires according to the model.
– After connecting, apply power to the switches and wait for the device to boot up.
– Connect to Switch and check Stack status.
!!! Thank you for following the article!!!
Xem tiếp...
